Announcement

Collapse
No announcement yet.

JD Maker Artist-D Pro 1st Look and Review is live

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • JD Maker Artist-D Pro 1st Look and Review is live

    Thanks to everyone on this forum for your suggestions. This is the first of what may end up quite a number of videos about IDEX 3d printers. Since I now have two of them in my shop I will be able to do a complete test of a number of techniques. I expect to cover slicers, creating models, modifying existing models, dissolvable supports, and more.


  • #2
    I'm all ears. IDEX is our immediate future as far as I can tell. But I'm much older than Irv, henceforth more naive, so let's see what happens!

    Comment


    • #3
      Irv Shapiro

      Hi Irv. First, just to clarify roon4660's comment in another thread, yes, my forum nickname is Ender5r (pronounced Ender-Fiver), rather than Ender-Three-R. No biggie.

      Now, on to real matters.
      1. JG Maker recommends setting the bed parameters to 310 x 310 x 350 in Cura. Not a big deal, but an extra 10mm in the X & Y just might come in handy on rare occasions.
        .
      2. Thank you for the info about Cura & JG Maker 'profiles'. I didn't realize you just open them as projects. I think I did do that with 1 of the files, simply because I recognized the .3mf extension as a Cura project file, but I hadn'r realized this is the proper way.
        .
      3. Thank you for confirming that it is good practice to set print & standby temps the same. I found lower standby temps annoying so I started setting them the same a little while ago. It's good to have confirmation.
        .
      4. Thank you for the Cura nozzle disable info. I wasn't aware of it. It's a nice, easy way to only use 1 nozzle for sure.
        .
      5. A brief howto on cleaning the brass brush nozzles would be nice.
      Looking forward to future videos. This printer is looking very interesting.

      Comment


      • Ender5r
        Ender5r commented
        Editing a comment
        repost the "cheat sheet"? Consider it done.

    • #4
      Thanks for the review of my review I am enjoying this collaboration and look forward to your comments. Sorry about getting your ID wrong. I have created a new forum for IDEX 3d printers and it would be great if you could repost your "cheat sheet" there.

      I just started learning IdeaMaker. It has real potential for both IDEX and traditional FDM printers.

      Comment


      • #5
        Great idea Irv to make a separate forum for IDEX printers.

        Comment


        • irvshapiro
          irvshapiro commented
          Editing a comment
          Thank you.
      Working...
      X