Announcement

Collapse
No announcement yet.

different % infill on design

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • different % infill on design

    I'm designing using Tinkercad. Is there a way in Cura to increase the infill of certain select portions of the imported .stl file? I need 1 part stronger than the rest of the design so I think I want the infill greater in that area.
    TIA, Phil

  • #2
    Yes. Check out this CHEP video, starting at about the 2 minute mark (the while thing is worth watching): https://www.youtube.com/watch?v=su_m5zV9rvA

    Cheers
    Last edited by Alan; 04-26-2021, 09:06 AM. Reason: Typo

    Comment


    • Phil
      Phil commented
      Editing a comment
      TYVM. The CHEP video was very helpful and did the trick with some help from a commenter below suggesting I double click the object when adjusting the supports to change the infill.

  • #3
    I like to use Prusa instead. I think it must work the same way more or less. I must check on that.

    Comment

    Working...
    X