If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As our community grows, it has become a bit harder to keep up with new posts. Here are some things that will help.
When you view a topic, there are two tabs at the top of the posts, one is called "posts," the other is called "latest activity." If you click on "posts," the newest replies will be on the bottom. If you click on "latest activity," the latest responses will be on the top.
If you want to be notified when new topics are created in a forum make sure you click on the subscribe button on the top right of the page.
Thanks for participating in the DrVax community. Irv
Announcement
Collapse
No announcement yet.
Anyone know where the 'Flow Control' setting is in Simpify3D
Ay yai yai. It really is still the wild west when it comes to 3D printing. I was thinking, after so many years, that the world of 3D printing would have settled down somewhat. My bad. Anyway, thanks very much for the info. I wonder. has anyone created a cross-reference document that lists what each 3D printing setting is called in all the slicing programs? That might be useful.
I have been planning to do a Cura, Simplify3D, and Prusa slicer cross-reference for a long time. So far I have been too lazy as it is a big job and I have struggled with the best way to film it as a video. Thanks for the push, I will move it back to the front burner.
I would love to help create a PDF cross-reference, but my knowledge of slicers is so thin at this point, I would be more of a hindrance than a help (gotta know your limits...).
Comment