Welcome to the DrVAX Community.
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As our community grows, it has become a bit harder to keep up with new posts. Here are some things that will help.
When you view a topic, there are two tabs at the top of the posts, one is called "posts," the other is called "latest activity." If you click on "posts," the newest replies will be on the bottom. If you click on "latest activity," the latest responses will be on the top.
If you want to be notified when new topics are created in a forum make sure you click on the subscribe button on the top right of the page.
Thanks for participating in the DrVax community. Irv
Folks,
Forum user Geit gave me a helpful push and I learned how to added additional attachment types to our forums. You can now attach/upload FCStd, F3d and STL files. In addition I have increased the PDF file size limit so I can more easily upload DrVAX video slides decks.
All the best. Irv
Basically, it's an addon to the bed leveling procedure using a sheet of paper. He further refines the process by printing small, 1-layer squares at the corners and center of his bed. I tried it and found it really makes a difference. Since you have a BL Touch, this could be a way to verify your BL Touch is fully dialed in.
Is there other low-hanging fruit I should check for dialing-in my printer?
Thanks
Yea i did the 100 mm extruder test when i replaced the stock plastic extruder on my ender 3 v2 with a all metal one. It was dead on..I replaced it because the plastic one broke when I was replacing the filament. Broke underneath so you couldn't see it but could feel it give when i push the lever in to remove the filament.
Comment