If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As our community grows, it has become a bit harder to keep up with new posts. Here are some things that will help.
When you view a topic, there are two tabs at the top of the posts, one is called "posts," the other is called "latest activity." If you click on "posts," the newest replies will be on the bottom. If you click on "latest activity," the latest responses will be on the top.
If you want to be notified when new topics are created in a forum make sure you click on the subscribe button on the top right of the page.
Thanks for participating in the DrVax community. Irv
There is really only one screw that you need to remove and that's the one between the 2 top rollers. The other screw to the right of that one is to remove the part fan from the plastic cover. I have already had to replace the hot end fan on mine as it went bad already. This is a command problem with the ender 3 v2. And as MarcSchuh suggest the fan wires for the part fan and the hot end fan are attached plus be careful of the thermistor wires as they can be easily damaged.
Tweet
Comment