Announcement

Collapse
No announcement yet.

PTFE tube failed

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • PTFE tube failed

    Hai welcome everyone I am new to 3D printer field . Last month I purchased AnetET4 model that's work good but now I have face problems under extrud due to PTFE tube connector failure...now I want purchass tube and 2 connector any one can suggest where I can purchase suitable tube and connector for my model...
    advance Thank you

  • #2
    I assume the Anet uses the standard PTFE tubing and connectors. They can bought be bought from Amazon. There is, for example, this complete kit:
    https://www.amazon.com/Authentic-Cap...s%2C174&sr=8-5

    Comment


    • #3
      Thank you for your response it very helpful...may I know exactly what model size connector used in Anetet4....

      Comment


      • #4
        I don't know the Anet specifically, but I assume it uses the M5 threaded connector, like pretty much all the lower cost 3D printers. In any case, they give both sizes in the kit.

        Comment


        • #5
          Thank you 👍👍👍👍👍🤝

          Comment


          • #6
            Please see this DRVAX video before you buy Capricorn tubing: https://www.youtube.com/watch?v=wZD_-aeODfkThe ANET hotend uses PTFE tubing that is smaller in diameter than Capricorn.

            Cheers

            Edit: I just noticed in the comments that ANET provides a link for a replacement: https://anet3d.es/products/pneumatic...ctor-with-tube
            Last edited by Alan; 07-12-2020, 11:40 AM.

            Comment


            • #7
              Good catch Alan. I hadn't seen that video. The power of the community comes through again; this time to save my butt. It's really a pity that it's not possible to use Captube. I think my first upgrade if I had an A4 would be to fit an all-metal hotend.

              Comment

              Working...
              X